equIpment

Use only synthetic brushes and rollers.

decantIng

make sure you have the right paint for the surface. if you’re not sure, check out our finishes page.

*

Decant the paint into a paint tray. Don’t use paint straight from the tin.

*

Clean the rim of the tin and reseal once the paint has been decanted.

*

Avoid returning paint from trays to the tin to avoid risk of contamination.

prevIously paInted surfaces

Primers and undercoats are not required when applying Pickleson products to previously painted surfaces when cleaned as follows:

Clean surfaces fully with sugar soap to remove any grease or other contaminants.

*

Use an antifungal cleaner to remove any surface mould.

*

Don’t attempt to remove grease or other contaminants by sanding only.

*

Once cleaned, lightly sand surface then clean with a lint free cloth.

DRYING TIME

Drying times will vary based on temperature and humidity.

*

pickleson products can be re-coated as soon as they are touch dry, usually between 20 minutes and one hour.

TEMPERATURE

pickleson products can be applied in temperatures between 5°C and 30°C.

*

Where temperatures are 5°C, some surface temperatures such as metal are likely to be much lower. Avoid application on surfaces that are below 5°C.

PROTECTION

No breathing apparatus or other personal protection is needed for the use of our products. However, it is recommended that overalls are used. In the unlikely event that you experience any skin sensitivity to our products please refer to our safety information.

*

Whilst it’s recommended to paint in a ventilated space, it’s not essential for our products.

*

pickleson products are engineered not to splatter when in use, however we recommend the use of appropriate drop sheets to protect other nearby surfaces and furniture.

CLEAN UP

All pickleson products are water-based, 100% pure acrylic. this means Tools and equipment can be easily cleaned with fresh clean water and without detergents.

*

Any residue of paint left in tins should be left to dry and go hard. Once hard, simply dispose of with normal waste.

STORAGE

To avoid spillage, always store and transport in a secure upright position.

*

Ensure that after use, rims of tins are cleaned, and lids are properly refitted and sealed to avoid contamination.

*

Only store pickleson products in their original tins.

*

Store all pickleson products between 5°C and 25°C away from direct heat and sunlight.

*

Products that are unopened can be stored for at least two years.

*

Opened and part used tins must have the lid securely fitted, and no contamination should be allowed to enter the paint.

*

All products will need to be stirred thoroughly prior to use following extended periods of time in storage.

For full detailed information see our safety data sheet.